
- Remove this product from my favorite's list.
- Add this product to my list of favorites.
MK2A Heated Bed
12V capable heated bed
Categories
12V capable heated bed
Exactly as described here, and also including, 1x 100K ohm thermistor, 1k resistor and 2 LED, you need basic soldering skills to solder the power wire! Please use a good power supply and thick copper wire to connect the heat bed. The thermistor is comes not soldered, too !
- The pads to solder onto have been greatly increased as shown in the picture below. The picture shows the wires prepared for soldering routed through the holes for extra security. This does not remove the need to use proper strain relief.
Copper plated holes as shown in reprap wiki: http://reprap.org/wiki/PCB_Heatbed
Tech specs heat bed MK2A
Tech specs for the EPCOS thermistor included in this set (this is the most popular thermistor used in reprap)
Content of package:
- 1 x MK2A PCB with 1K resistor and 2 red led soldered
- 1 x 100K ohm thermistor, un-soldered (all packed one by one in each one small bag)
No customer comments for the moment.